Sensors
Arduino_BMI270_BMM150
Allows you to read the accelerometer, magnetometer and gyroscope values from the IMU on your Arduino Nano 33 BLE Sense Rev2
The ArduinoBMI270_BMM150 library allows you to use the inertial measurement unit (IMU) system available on the Arduino® Nano 33 BLE Sense Rev2 board. The IMU system is made up up the 3-axis accelerometer and gyroscope BMI270, and the 3-axis magnetometer BMM150. The IMU is connected to the Nano 33 BLE Sense Rev2 board's microcontroller through I2C. The values returned are signed floats.
To use this library:
1#include "Arduino_BMI270_BMM150.h"The ArduinoBMI270_BMM150 library takes care of the sensor initialization and sets its values as follows:
- Accelerometer range is set at ±4 g with a resolution of 0.122 mg.
- Gyroscope range is set at ±2000 dps with a resolution of 70 mdps.
- Magnetometer range is set at ±1300 uT with a resolution of 0.3 uT.
- Accelerometer and gyrospcope output data rate is fixed at 99.84 Hz.
- Magnetometer output data rate is fixed at 10 Hz.
begin()
readAcceleration()
readGyroscope()
accelerationAvailable()
gyroscopeAvailable()
accelerationSampleRate()
gyroscopeSampleRate()
readMagneticField()
magneticFieldSampleRate()
magneticFieldAvailable()